# Chaining on Sloping Ground | Guide to Surveying and Levelling

#### Chaining on Sloping Ground | Surveying and Levelling

There are two methods for determining horizontal distance on sloping ground.

1. Direct Method
2. Indirect Method

#### Direct Method of Chain Surveying

This method is also known as “Stepping Method”.

The horizontal distances are directly measured by the process of stepping.

#### Procedure

A path of chain or tape is stretched out from ‘P’.

The path length of chain or tape depends on the steepness of the ground.

The follower holds the zero end of the chain at ‘P’ and directs the leader at P1 to be in the line of PQ and stretch the chain or tape above the ground in horizontal line.

The leader then transfers the point ‘P1’ to P2 on the ground by means of plumb bob or dropping a pebble or an arrow,

Now the followers take the new position ‘P2’ and directs the leader to move forward and stretch the tape or chain in a line of PQ.

Now the followers take the new position ‘P2’ and directs the leader to move forward and stretch the tape or chain in a line of PQ and the new position is P3.

Again the leader transfers the point P3 to P4 on the ground as done earlier.

This process is repeated till the point Q is reached.

Horizontal distance PQ = S1 + S2 + S3 + S4 + S5

#### Indirect Method of Chain Surveying

In this method, the sloping side is measured on the ground and later it is converted into the horizontal equivalent using geometrical condition.

The following methods are adopted for calculating horizontal distance indirectly:

• By measuring angle of inclination
• By measuring difference of levels
• By hypotenusal allowance

### 7 thoughts on “Chaining on Sloping Ground | Guide to Surveying and Levelling”

1. I conceive this internet site has got very excellent written
subject matter posts.

2. tharaka :
good. this was helped to me to learn.

3. good. this was helped to me to learn.

4. chaining on sloping ground by direct & indirect method is answer of hypotenusal allowance